Publicité
Les langues disponibles
Les langues disponibles
▶
tWTR
Minimum time interval between the end of write data burst and the start of a col-
umn-read command. It allows I/O gating to overdrive sense amplifiers before read
command starts.
▶
tRRD
Specifies the active-to-active delay of different banks.
▶
tRTP
Time interval between a read and a precharge command.
▶
tFAW
This item is used to set the tFAW (four activate window delay) timing.
▶
tWCL
This item is used to set the tWCL (Write CAS Latency) timing.
▶
tCKE
This item is used to set the tCKE timing.
▶
Advanced Channel 1/ 2 Timing Configuration
Press <Enter> to enter the sub-menu. And you can set the advanced memory timing
for each channel.
▶
tRRDR/ tRRDD/ tWWDR/ tWWDD/ tRWDRDD/ tWRDRDD/ tRWSR
These items is used to set the memory timings for memory channel 1/ 2.
▶
VDroop Control
This item is used to select the VDroop control mode.
▶
CPU Vcore/ DRAM Voltage/ PCH 1.05
These items are used to adjust the voltage of CPU, Memory and chipset.
▶
Current CPU Vcore/ Current DRAM Voltage
These items show current CPU Vcore/ DRAM voltage. Read-only.
▶
Overclocking Profile
Press <Enter> to enter the sub-menu.
▶
Overclocking Profile 1/ 2/ 3/ 4/ 5/ 6
Press <Enter> to enter the sub-menu. In the sub-menu, these items are used to save
the current settings, and you can to load the settings from the stored profile.
▶
OC Retry Count
When overclocking has failed, setting this item as [1, 3] will allow system to reboot
1/ 3 times with the same overclocked configuration. If overclocking has failed every
time, the system will restore the defaults.
▶
CPU Specifications
Press <Enter> to enter the sub-menu. The submenu shows the information of installed
CPU.
▶
CPU Technology Support
Press <Enter> to enter the sub-menu. The sub-menu shows the installed CPU tech-
nologies. Read only.
En-33
Publicité
