Frequency Selection - BST UDR-103 BP Manuel D'utilisation

UDR-103 BP

FREQUENCY SELECTION

BATTERIES CHANGING
- Open batteries covers
- Insert two AA 1.5V batteries. Respect polarity
- Close batteries cover
- Switch the transmitter on
Expected life for an Alkaline battery is approximately 8 hours.
IR SYNC OPERATING
© Copyright LOTRONIC 2012
Enter in master mode :
While the" Master" is shown, release set + power, then press power + set to enter the
"Master".
Frequency selection :
Press and hold the set button till the group is flashing. Press and release to change the
frequency in 1 MHz increments. Press and hold to scroll quickly.
Switch to channel select by pressing the power button.
Press and hold the set button till the channel is flashing. Press and release to change
the frequency in 25 Khz increments. Press and hold to scroll quickly.
Exit of master mode :
press power + set buttons to exit the "Master".
- Select frequency on receiver ( manual mode or auto scan mode )
- Press 4 times the menu button then press up button
- Place IR sensor of receiver and transmitter face to face , average
distance : 15cm
- The frequency setting of transmitter will be automatically adjust.
WWW.BSTDJ.COM
Page 12