Operating - BST UDR-103 BP Manuel D'utilisation

UDR-103 BP

OPERATING

© Copyright LOTRONIC 2012
Group selection :
Allows manual selection of a frequency group. Pressing UP increases the group number
by one. Pressing down decreases the group number by one when the correct frequency
group is displayed, press MENU button to other mode,or do not pressing any button ,after
5 second the receiver automatic scanning an available frequency channel,and transmitting
infrared SYNC singul.For best results when operating multiple systems, set al1 systems to a
single group; then set each system to a unique channel within that group.
Frequency selection :
Allows manual selection of a frequency channel. Press menu three times and Pressing up or
down to increase or decrease the channel number by one,correct frequency is displayed.
Pressing MENU to IR menu mode,and press MENU again to escape set up mode.
Auto scan :
Allows to enter the scan menu mode. Press menu button two times and Pressing up button to
scan an available channel frequency. After scanning an available channel, the channel number
.
and frequency is displaying
IR SYNC :
Either of Group selection,channel selection and scan menu mode,after setting up it will
automatically enter IR SYNC mode.When "IR is displaying,press up button to SYNC the
transmitter.You can also enter IR SYNC mode by pressing MENU button four times
Receiver lock and unlock :
Hold down the menu key and press up to lock or unlock the receiver. When locked, the current
receiver settings cannot be changed.
Antenna status :
lndicates RF activity. Only one antenna is active at any one time.
WWW.BSTDJ.COM
Page 10