Olympia A 4040 Mode D'emploi page 17

All manuals and user guides at all-guides.com
Cleaning and Servicing
Deposits and residual adhesive on the transport rollers can influence the
results of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual
adhesive is removed and taken up by the paper when ejected. Repeat the
process several times.
Disconnect the power plug before starting to clean the unit with a damp
cloth. If necessary, the housing can be cleaned using a cloth moistened with
clean water with a little mild soap applied. Never use any solvents or
aggressive cleaning agents.
Troubleshooting
Fault
• Red LED (POWER) does not light
up
• Unit does not respond
• Foil jam
• Laminated foil is not completely
transparent
Corrective measures
• Check that the power plug has
been properly connected to the
power socket.
• If the fault cannot be cleared,
contact our hotline.
• Check the foil pockets being used
are the correct size.
• Only use pouches of the size
specified.
• Ensure that the pouch has been
inserted correctly in the unit.
• To clear the fault, follow the
instructions in the Section "Clearing
Foil Jams".
• Laminate the same foil again to
improve the lamination result.
Conformity of the equipment to the
EU directives is confirmed by the
CE symbol.
17