Kolpin 2622 Instructions D'installation

Please read and understand these instructions completely before installation to avoid injury to yourself, damage to the vehicle or accessory.
Be certain to follow all specifications. For proper installation, two people are required
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation. Torque specifications must be followed when tightening bolts.
ITEM PART NAME
A
Instruction
B
bag
Note that a few components of the vehicle are not depicted on the drawings to make the installation instructions
1. Installation
a) Find a clean flat area where you can lay down the windshield. Insert all grommet bumpers to the windshield as shown. It's strongly
recommended to keep the protective film on at this step.
b) Temporarily remove OEM headrests and backrest fasteners from vehicle as shown below.
2622 - Installation instructions for Polaris Ranger XP 2010 rear windshield revision 00
INSTALLATION INSTRUCTIONS
POLARIS RANGER XP 2010 REAR WINDSHIELD
PART # 2622
Parts List
(parts available with kit only and not available separately)
Windshield
Includes : 2 dome head screws M6 x 20, 2 plastic washers M6, 2 shoulder washers M6, 2 flange
Hardware
Front view
DESCRIPTION
CNC rear windshield cut-out made of 1/8" thick GE FMR polycarbonate
nylon locknuts M6 and 6 grommet bumpers
as clear as possible.
OEM
headrest
screws (4)
OEM headrest
Side view
OEM headrest
washers (4)
(2)
OEM backrest screws (4)
WWW.KOLPIN.COM
QTY
1
1
Detail
view
1