NAD S70 Mode D'emploi page 16

All manuals and user guides at all-guides.com
Problem
Remote control works
intermittently or doesn't
work at all
Sleep Timer and Timer
functions can't be activated
Although activated, Sleep
Timer and Timer function do
not work properly or at all
Sometimes not all
components respond to
On/Off command, causing
these to be "out-of-sync" for
stand-by/operating status
Display is difficult to read
GB
16
TROUBLESHOOTING GUIDE
Cause
• Battery flat or snap-on
connector incorrectly
attached
• IR transmitter or receiver
windows obstructed
• IR receiver on components
are in direct sun or very
bright ambient light
• These functions are
available only if clock is
activated
• IR transmitter or receiver
windows obstructed
• IR receiver on components
are in direct sun or very
bright ambient light
• Remote control is just out
of range
• Too little or too much
contrast
• Battery almost flat
Solution
• Check or replace battery
• Remove obstruction
• Place unit away from
direct sun, reduce amount
of ambient light
• Activate clock
• Remove obstruction
• Place unit away from
direct sun, reduce amount
of ambient light
• Reduce operating distance
• Connect NAD-Link
between components
• Adjust display's contrast
level
• Replace battery