Publicité
Les langues disponibles
Les langues disponibles
SET LIGHT CONTrOLS
1. Select desired ON-TIME for the light to stay on after
motion is detected (1, 5, or 20 minutes).
2. Set D
B
ual
rite
Normal.
Note: Meets the ENERGY STAR
D
B
®
ual
rite
minutes.
3. Reinstall cover.
4. Turn power on at the fuse or circuit breaker and
light switch.
Range ........................................ Up to 30 ft. (9,1 m). [varies with surrounding temperature]
Sensing Angle ........................... Up to 190°
Electrical Load ........................... Up to 100 Watt Maximum Halogen, 78 mm T-type
Power Requirements ................. 120 VAC, 60 Hz
Operating Modes ....................... TEST, NORMAL, and MANUAL MODE
Time Delay ................................ 1, 5, 20 minutes from last motion sensed
D
B
Feature .................... Dusk-to-Dawn
®
ual
rite
SyMPTOM
Light will not come
on.
Light comes on
in daylight.
Light comes on for
no apparent rea-
son.
Get user manuals:
See SafeManuals.com
control to Dusk-to-Dawn (DIM) or
®
guidelines when
®
function is off and ON-TIME is 1 or 5
SPECIFICaTIONS
TrOuBLESHOOTING GuIDE
POSSIBLE CauSE
1. Light switch is turned off.
2. Halogen lamp is loose or
burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect (re-
check after dark).
5. Incorrect circuit wiring, if this is
a new installation.
1. Wall light may be installed in a
relatively dark location.
2. Wall light is in Test. (Set control
switch to an ON-TIME position).
1. Light control may be sensing small
animals or automobile traffic.
2. D
B
Timer is on.
®
ual
rite
8 ft.
(2.4 m)
30 ft.
(9 m)
Maximum Range
The detector is less sensitive to motion directly towards it.
Motion
Sensor
Least Sensitive
SyMPTOM
POSSIBLE CauSE
L i g h t t u r n s
1. Wall light may be installed in a relatively
off too late in
dark location.
Dusk-to-Dawn
setting.
Light stays on
1. Wall light is located too close to nearby
continuously.
objects that cause heat to trigger the
sensor such as an air vent, dryer vent,
or brightly-painted, heat-reflective
surface.
2. Wall light is in D
3. Light control is in Manual mode (Switch
to Normal).
Light flashes
1. Heat being reflected from other objects
on and off.
may be affecting the sensor. (Move or
cover other objects to find which ones
are causing the problem).
2. Wall light is in the Test mode. Return
to the 1, 5, or 20 minute timer mode.
4
190°
Maximum
Coverage Angle
Motion
Most Sensitive
B
mode.
®
ual
rite
598-1132-06
Publicité
