Schartec 3 Serie Manuel D'utilisation page 22

12) Lift the motor and insert the screw into the front motor mount.
13) Remove the motor cover, loosen the screw and remove the bolt. See Figure 15. Now lift the rear of the motor
and move the gate until the motor can be locked to the rear bracket as shown in Figure 16. Slide the bolt through
the hole provided in the motor and through the rear bracket. Tighten the screw for the bolt. See Figure 17.
Figure 15
14) Tighten the bolt with the nut on the rear bracket, then loosen the nut half a turn to allow the motor arm to rotate.
15) Now tighten the screw with the nut on the front bracket. Tighten this screw completely.
16) Now connect the motor cable (see Fig. 19) and the Hall sensor cables (see instructions for the P190 control
unit). Use flexible 5-core 1.5 mm² rubber cables for this purpose.
17) Close the motor cover again and tighten the cover screws.
Motor
18) Manual unlocking of the motor: Please note that the release key may only be turned slightly. If the force is too
high, the screw and the thread can be damaged.
19) Turn the round disc on the motor towards "Open". See Figure 21.
20) Slide the cover unlocking forward. See Figure 22.
21) Use the manual release key and turn the release counterclockwise until it stops.
Figure 21
Figure 16
1
3
2
Figure 19
Positive (+)
Negative (-)
Figure 18
A
B
Figure 22
22
Figure 17
3
1
2
Figure 20
Figure 23