Publicité
Les langues disponibles
Les langues disponibles
Installation
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage and before all other connections have
been made.
• Do not cover any vents and make sure that there is a space of several centimeters around the unit for ventilation.
Connection
• Connect the Power Cord (26) to AC outlet.
• Turn the Power On/Off Knob (16) clockwise until Power LED Indicator (17) light up. It's mean the power supply is
normal. Now your system is ready to play music.
1
Turn on the Power (16) and select Function knob (5) to "Tuner" position.
2
Select the desired band by Radio Band Selector(2)
3
Tune to the required station by turning the Tuning Knob (18).
4
Adjust the Volume Knob (16) to desired volume level.
FM & FM-stereo reception
• Set the Radio Band Selector (2) at "FM" position, program are received in Mono mode. In particular when stereo
signal are weak. It is preferable to receive the program in Mono.
• Set the Radio Band Selector (2) at FM-ST" position for receiving stereo programs. The FM-Stereo LED Indicator
(6) will light up to show FM Stereo program is receiving.
Hints for best reception:
• AM: The receiver has a built-in bar antenna. If AM reception is weak. Slight rotate or re-positioning of the unit
will usually improve the AM reception.
• FM: The receiver has a built-in FM Wire Antenna (25) hanging at the rear cabinet. This wire should be totally
unraveled and extended for best reception.
• Remove the stylus protector.
• Be sure that the tone arm is being detached from the tone arm rest before operating and re-secured again after
wards.
1
Select to "Phono" function from Function Selector(5)
2
Set the speed selector to the proper position depending on the record to be played.
3
Place the record on the platter(use the Spindle Adaptor if required).
4
Lift the tone arm from the rest and slowly move it to the record side.
5
The platter will start to rotate.
6
Place the tone arm to the desired position of the record.
7
Adjust the volume to the desired level.
8
At the end of the record, the platter will automatically stop rotating.
9
Lift the tone arm from the record and return to the rest.
10 To stop manually, lift the tone arm from the record and return it to the rest.
All manuals and user guides at all-guides.com
Getting Started
Listening to Radio
Listening to Phono
10
Publicité
