Black & Decker KA200 Manuel D'instructions page 29

REMOVING THE SIDE HANDLE
Proceed as follows:
ADJUSTING THE SIDE HANDLE
Proceed as follows:
DUST EXTRACTION SYSTEM
Most of the dust from the work surface is collected in
the dustbag. The extraction fan of your multi sander
draws the dust from the surface through the holes in
the base. The dust then passes through the fan shroud
to the dustbag. You can also use your multi sander with
a vacuum cleaner. A special adaptor is available from
Black & Decker as an accessory.
EMPTYING THE DUSTBAG
Disconnect the plug from the electricity supply.
applying light pressure
making sure that the
paper follows the shape.
Never use your sander
without sandpaper.
Turn the handle anti-
clockwise and
unscrew completely.
Remove the
connecting shoulder.
Unclip the metal clip.
Loosen the handle
slightly. Move the metal
clip around the body of
the sander until the
side handle is in the
desired position.
Tighten the handle.
Hold your multi sander
vertically with the
dustbag facing
downwards. Squeeze
the sides of the
dustbag together,
adjacent to the finger
grips and pull the bag
gently. Empty the
dustbag and replace on
the sander. A click is
heard when the dustbag is correctly fitted. The plastic
baffle is removable. However, it is not necessary to
remove the baffle when emptying the dustbag. Do not
wash the dustbag. Empty the dustbag every 10 minutes.
AUTOMATIC BRAKE SYSTEM (ABS)
(KA200/KA220/KA220E/KA230E)
Your multi sander has an automatic brake system
(ABS). This feature gives you optimal control as it
keeps the speed of the disc below that of the motor
when your sander is not on the work surface. When
your sander is switched off, the disc stops very quickly.
HANDY HINTS
• Do not apply excessive pressure when you use your
multi sander, especially in the random orbit mode.
• Replace the sandpaper when it is worn.
• Use high grit sandpaper for a fine finish. As a
general rule, start with coarse grits and gradually
change to the finer grits for the final finish.
• When using your multi sander to sand profiles be
sure to keep the profile square to the workpiece.
• Smaller radii sanding profiles work better with finer
grit sandpaper.
• Ensure that the platen is flat on the work surface
whilst sanding.
EC DECLARATION OF CONFORMITY
We declare that units:
KA200, KA210, KA210E, KA220, KA220E, KA230E
conform to 89/392/EEC, 89/336/EEC, EN55014,
73/23/EEC, EN55104, EN50144
A weighted sound pressure 77.1dB (A)
ENGLISH
You can hold your
multi sander in various
positions for maximum
comfort but make sure
you do not block the air
intake slots.
29