Black & Decker KA200 Manuel D'instructions page 28

ENGLISH
the allen key provided. Press the base on firmly when
tightening the screw.
REVERSING THE POINTED BASE
(KA210/KA210E/KA220/KA220E/KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
washer and the screw. Tighten the screw using the
allen key provided. Press the base on firmly when
tightening the screw.
FITTING THE SANDPAPER (POINTED BASE)
Proceed as follows:
Disconnect the plug from the electricity supply.
use a full sheet of sandpaper.
TIP COMPONENTS (POINTED BASE)
(KA210/KA210E/KA220 /KA220E/KA230E)
When the whole tip is worn, replace it with one of the
spare tips provided. The tip of the backing pad is
removable. When the front part is worn, turn the tip.
When the tip is completely worn, replace the tip. Spare
tips are available as accessories. When the tip of the
28
Turn the screw
anticlockwise using the
allen key provided in
the handle. Remove the
screw and the washer
from the spindle. Hold
the base in position
with the point facing
rearwards. Fit the
Detach the two
diamond-shaped tips
from the main sheet.
Place the sandpaper on
the pointed base, making
sure the holes of the
paper and the base are
aligned. Never use your
multi sander without
sandpaper and always
Each sheet of
sandpaper has a
removable tip, with two
spare tips attached. To
obtain maximum use
from each sheet, detach
and turn the tip when the
front part is worn.
hard plastic tip holder is worn, remove the screw and
turn the holder. Spare holders are available as accessories.
FITTING THE PROFILE BASE (KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
firmly when tightening the screw.
FITTING THE SANDING PROFILE (KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
the profile base. The sanding profile will now be
positively located. The sanding profile can be removed
by depressing the small black square section which is
visible at the front of the profile base, whilst pulling the
profile away from its locating slot.
FITTING THE SANDING PAPER (PROFILE BASE)
(KA230E)
Proceed as follows:
Disconnect the plug from the electricity supply.
With the profile fitted in the base, fit the paper by
Position the profile
base on the spindle,
with the long section
pointing towards the
front of your sander.
Make sure the legs fit
into their housings.
Place the washer in
position on the base
and fit the screw using
the allen key provided.
Press the base on
There are six sanding
profiles supplied, each
being different in size
and shape. Select the
sanding profile most
suitable for the task
and push into the slot in
the front of the base.
To do this, first locate
one end of the sanding
profile into the recess
at the back of the
profile base slot, then
push the other end so
that it locates in the
recess in the front of