Publicité
Les langues disponibles
Les langues disponibles
VI. MAINTENANCE AND STORAGE
WARNING!
Before any intervention on product, always disconnect it from the air supply.
WARNING!
Spray material or solvent may be harmful if inhaled or in contact with skin.
Always wear safety glasses, gloves and respirator when handling the substances.
Reminder: In order to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage. Any breach or inadequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
6.1- General cleaning after every use
• Remove the paint container, empty remaining material into a suitable sealed container, and
clean thoroughly with the appropriate solvent and clean cloths.
• Clean the nozzle assembly of the gun, lid and gasket of the paint container.
• Transfer a small amount of solvent into the clean paint container and restore it to the gun.
• Connect the gun to the air supply.
• Direct the gun towards an empty container and spray the solvent through the gun into the
container, until the spray is clear of any paint.
• Turn off the air supply and disconnect the gun.
• Release the paint container, empty remaining solvent into the disposal container, and let all
components dry thoroughly.
• Restore paint container for storage.
6.2- Cleaning of nozzles and needles
• WARNING! The precision-made nozzles and needles must be handled with care. Damage
and alterations will result in deteriored performance or faulty spray.
• WARNING! Needles have a sharp point. Handle with care to avoid puncture wounds and
other injuries.
• Refer to Figure 2 for assembly diagram, carefully disassemble the spray gun, remove the
nozzle assembly and fluid control needle.
• Soak the nozzles and needle in a suitable solvent that dissolves any dried material and clean
with a suitable soft brush.
• NOTE: Never soak the entire spray gun in solvent, as this will damage the packings and
remove lubrication.
• Carefully blow all components to dry with filtered compressed air.
6.3- Lubrication
• Slightly lubricate all packings, bearings and dynamic O-rings with a specialised spray gun
lube, and apply a small amount of petroleum jelly to springs.
6.4- Storage
• Clean the product before storage.
• Keep product, instruction manual and accessories (if any) in the original packaging.
• Store the product in a clean environment, where is not freezing or too hot (exceed 50 ̊ C ).
• Keep out of reach of children (e.g. lock it up).
Page 13 / 22
Publicité
