Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
4.2- Assembly
WARNING!
Before any intervention on product, always disconnect it from the air supply.
Fitting the pressure regulator/gauge
• This tool is supplied with a pressure regulator/gauge.
•
Apply PTFE tape (not included) to the screw threads of the air inlet (8). This will help to
maintain an air tight seal.
• Remove the protective plug from the air inlet.
• Using a spanner (not included) to fit the pressure regulator/gauge into the air inlet.
Fitting the quick connector
• This tool is supplied with a male quick connector.
• Apply PTFE tape (not included) to the screw threads of the pressure regulator/gauge. This
will help to maintain an air tight seal.
• Using a spanner (not included) to fit the quick connector into the pressure regulator/gauge.
Fitting the paint container
• Insert the supplied filter screen to the top opening of the spray gun.
• Connect the paint container (2) by screwing it in to the top opening of the spray gun. Gently
tighten with a suitable spanner (not included).
• NOTE: The filter screen is used to protect against small particle comtaminants, use of this
filter screen is optional.
Paint preparation
• WARNING! Make sure the type of paint, solvent used and the viscosity is suitable for the
material and type of this spray gun.
• Mix, condition and filter the material to be sprayed according to the paint manufacturer's
recommendations.
• Refer to the paint manufacturer's guidelines for storing and disposal of prepared material.
Filling the paint container (2)
• Make sure the spray gun is disconnected from the air supply.
• Remove the paint container lid (1).
• Fill the paint container to the required level.
• Restore the paint container lid and tighten by hand.
Fluid flow adjustment
• The fluid flow can be adjusted by slowly turning the fluid flow control knob (4).
• To increase the flow, turn the knob counter-clockwise slowly.
• To decrease the flow, turn the knob clockwise slowly.
Page 11 / 22
Publicité
