Publicité
MAINTENANCE
All manuals and user guides at all-guides.com
A
Full
Figure 11
A
Figure 12
ADJUST SKID HEIGHT
WARNING: Always turn unit off, remove ignition key,
and disconnect the spark plug wire before making
any repairs or adjustments.
This snowthrower is equipped with two height adjust skids, secured to the
inside of the auger housing. These elevate the front of the snowthrower.
When removing snow from a hard surface area such as a paved driveway
or walk, adjust the skids up to bring the front of the snowthrower down.
When removing snow from rock or uneven construction, raise the front of
the snowthrower by moving the skids down. This will help to prevent rocks
and other debris from being picked up and thrown by the augers.
To adjust skids, proceed as follows:
1. Place a block (equal to height from ground desired) under scraper bar
near but not under skid.
2. Loosen skid mounting nuts (A, Figure 13) and push the skid down
(B) until it touches the ground. Retighten mounting nuts.
3. Set skid on other side at same height.
NOTE: Make sure that snowthrower is set at same height on
both sides.
WARNING: Be certain to maintain proper ground
clearance for your particular area to be cleared.
Objects such as gravel, rocks, or other debris, if struck
by the impeller, may be thrown with sufficient force to
cause personal injury, property damage, or damage to
the snowthrower.
B
B
18
A
1/8" - 3/16"
(3 mm - 5 mm)
A
1"
(2,5 cm)
Figure 13
Publicité
