Philips pro travel styler HP4621 Mode D'emploi page 6

To remove the brush from the hair
- It is not necessary to rotate the brush in the opposite direction. Simply push and
turn the bristle retraction knob in the direction of the arrows (fig. 10) and the bristles
will retract.
- Slide the metal bar sideways out of the curl.
This will prevent the curl from getting spoilt or tangled and makes it last longer.
Cleaning
The brushes can be cleaned with a small brush or a dry cloth.
Storage
The appliance can be hung from the hanging loop
(fig. 11).
Important
• Before connecting the appliance, check that the
voltage(s) indicated on the type plate correspond(s) to
the local mains voltage. Also check whether the Voltage
Selector is positioned in the correct voltage
corresponding with the local mains voltage.
• Do not use this product near water in e.g. baths, washbasins, sinks. If
the product falls into water, unplug it immediately and dispose of it. It
must not be used again.
• Always ensure that the attachments are completely dry (on the inside as
well as the outside!) before affixing them to the styler.
• Always switch the appliance off before putting it down, even if it is only
for a moment.
• For additional protection, the installation of a residual current device
(RCD) with a rated residual operating current not exceeding 30 mA is
advisable in the electric circuit supplying the bathroom. Ask your
electrician for advice.
All manuals and user guides at all-guides.com
6
11