Porter Cable SAW BOSS 345 Manuel D'utilisation page 13

All manuals and user guides at all-guides.com
TO ADJUST 45° BEVEL POSITIVE STOP
Disconnect the tool from the power source!
1. Raise the lever (A) Fig. 5. Tilt the
base until the top of the stop
screw (B) Fig. 6 contacts the
extension on the bevel segment.
Tighten the locking lever.
2. Turn the saw upside down,
retract the telescoping guard,
and check the 45° angle (Fig. 8).
3. To adjust, raise the lever (A) Fig.
5 and turn the stop screw until
the angle is correct.
LINE OF CUT INDICATOR
A line of cut indicator (A) Fig. 9 is provided at the front of the base. Use the
left edge of the notch of this indicator to make 90° cuts. Use the right edge
of the notch to make 45° cuts. To adjust this indicator:
Disconnect the tool from the power source!
1. Adjust the saw for a 90° cut.
2. Loosen the two screws (B) Fig. 9.
3. Place a straight edge along the side of the blade, touching the set of the
blade teeth at both the front and rear of the blade (Fig. 10).
Avoid contact with the blade teeth to prevent personal
injury.
4. Align the left edge of the notch in the indicator with the straight edge
and tighten the two screws (B) Fig. 9.
A
B
Fig. 9 Fig. 10
13
Fig. 8