Porter Cable SAW BOSS 345 Manuel D'utilisation page 12

All manuals and user guides at all-guides.com
ADJUSTING FOR BEVEL CUTS
Disconnect the tool from the power source!
1. Raise the lever (A) Fig. 5.
2. Tilt the saw base until the desired
graduation line on the bevel
segment (B) Fig. 5 aligns with the
indicating mark (C) Fig. 5 on the
bracket.
3. Press the lever (A) to the locked
position.
90° and 45° BEVEL POSITIVE STOPS
This saw is equipped with adjustable
positive stops for both 90° cuts (A)
Fig. 6 and 45° bevel cuts (B) Fig. 6.
These stops were set at the factory.
However, check them occasionally to
ensure accuracy.
TO ADJUST 90° POSITIVE STOP
Disconnect the tool from the power source!
1. Raise the lever (A) Fig. 5, and position the base for 90° cuts. Place the
top of the base in contact with the bottom of the stop screw (A) Fig. 6,
and tighten the locking lever.
2. Turn the saw upside down,
retract the telescoping guard,
and see if the blade is 90° to the
base (Fig. 7).
3. To adjust, raise the lever (A) Fig.
5. Keep the top of the base in
contact with the stop screw. Turn
the stop screw until the blade is
90° to the base.
A
C
A
Fig. 6
Fig. 7
12
B
Fig. 5
B