KVS 15MTI Instructions D'installation page 32

6.14
6.14 Installation in a corner
Installation in a corner
Type Heat pump B (in mm)
600 15MTI / 15TTI
700 20TTI
Table of dimensions for installation in a corner
Installation in a corner with adaptor
Type Heat pump B (in mm)
600 15MTI / 15TTI
700 20TTI
Table of dimensions for installation in a corner with adaptor
6.15 Installation on a wall
Installation on a wall
E-12
All manuals and user guides at all-guides.com
D1 (in mm) E (in mm)
650 301 852
745 254 852
D3 (in mm) E (in mm)
650 301 852
745 254 852
Type Heat pump
600 15MTI / 15TTI
700 20TTI
Table of dimensions for installation on a wall
ATTENTION!
Either a light well or a rain guard should be used for the air outlet to avoid
shorting the air circuit.
7 Start-up
7.1 General
To ensure that start-up is performed correctly, it should only be
carried out by an after-sales service technician authorised by the
manufacturer. Only then can an extended warranty period of
3 years in total be granted (see Warranty Service).
7.2 Start-up
The following items need to be checked prior to start-up:
The heat pump must be fully connected, as described in
Chapter 6.
Any valves that might impair proper water flow in the water
circuit must be opened.
The air intake and air outlet paths must be clear.
The ventilator must turn in the direction indicated by the ar-
row.
The remote control must be operational.
Ensure the condensate outflow functions properly.
After connecting the operating voltage and switching on the
swimming pool heat pump, there will be a pre-programmed
5-minute compressor pause time before the heat pump
starts up.
The bypass and regulator valves must be set so that the mi-
nimum water flow is in accordance with the Device Informa-
tion. The following maximum temperature spreads between
water inlet and water outlet are set for the operating point.
External air tempera-
ture
between water inlet and water
From To
18° C 20° C
15 °C 18° C
B (in mm) E (in mm)
650 852
745 852
Max. temperature spread
outlet
6-7 K
5-6 K