Battery Charging Procedure; Working Environment; Assemble Battery - Kamikaze KV 300 Manuel D'utilisation

ELECTRICAL PRUNING SHEAR
• Re-charging battery when indicator shows one LED light.
• Do not charge batteries over 5 hours, don't use up completely otherwise
battery life will be reduced.
• Need to replace battery if battery running time is not enough. Users can
only use the original equipment manufactured by the customer center
(OEM) battery pack.
• Keep safety rules and environment protection information in mind all the time.

10.1 BATTERY CHARGING PROCEDURE

• Charge at temperature of + 10°C ~ + 22°C indoor.
• Make sure the switch at "OFF" position before charging.
• Connect adaptor of charger with battery correctly.
• Make sure specifications on battery and adapter matched before charging.
• Red LED light on the charger indicates the battery is charging, green LED
light indicates fully charged, average charging time is about 4-5 hours.
• Pull out connector from power and battery after fully charged.
• Please make sure the battery charged at least once every three months
when the battery is not using.

11. WORKING ENVIRONMENT

• Keep temperature of environment at 0°C ~ 45°C when charging battery,
-10°C ~ +60°C when battery is working.
• Keep tool at temperature of -5°C ~ 30°C when working
• Do not use in explosive atmosphere or near flammable substances or gases.
• Do not use in case of rain or on wet branches

12. ASSEMBLE BATTERY

Please check that the pruning shears, wires and batteries are clean and dry,
and then follow the steps below to assemble:
68
www.kamikazevolpi.com