Publicité
Les langues disponibles
Les langues disponibles
This rangehood can be installed as either ducted or ductless. When installed ductless, the rangehood vents out of grates on either
side of the lower chimney. Ductless installations require a Ductless Conversion Kit, available from your dealer.
WARNING! BEFORE MAKING ANY CUTS OR HOLES FOR INSTALLATION, DETERMINE WHICH VENTING METHOD WILL
BE USED AND CAREFULLY CALCULATE ALL MEASUREMENTS.
(vented to the outside)
The Glassy Isola chimney is highly adjustable
and designed to meet varying ceiling heights
as indicated in FIGURE 4. The chimney can
be adjusted for ceilings between 7' 9 7/8"
and 8' 10 7/8" depending on the distance
between the bottom of the hood and the
cooktop (distance x in FIGURE 4).
For higher ceiling installations, the High
Ceiling Chimney Kit includes an additional
support structure which adds 21" to the
ceiling heights in FIGURE 4.
NOTE: The chimney structure can reduce
down to a 27" minimum height. To reduce
the height, the middle section of the
support structure (FIGURE 5) needs to
be removed. Out of the box, the minimum
chimney length is 32". Subtract 5" from
all minimum ceiling height calculations
in FIGURE 4 if removing the middle
section. Contact Faber at 508-358-5353
for more information.
FIGURE 5
PLAN THE INSTALLATION
DUCTED
INSTALLATION DIMENSIONS
upper
chimney
cover
lower
chimney
cover
canopy
x = distance from hood to cooktop
(varies depending on installation)
min - 24", suggested max - 30"
also consult cooktop
manufacturer's recommendation
cabinet base
8
min
3/8"
15
max
3/8"
23
5/8"
1 7/8"
min & max ceiling height examples
x = 24"
x = 26"
min
min
x
7'
7'
9 7/8"
11 7/8"
max
max
8'
8'
4 7/8"
6 7/8"
36"
WARNING
DUE TO THE SIZE AND WEIGHT
OF THIS RANGEHOOD, THE
SUPPORT MUST BE FIRMLY
ATTACHED TO THE CEILING.
For plaster or sheet rock ceilings,
the support must be attached to
the joists. If this is not possible,
a support structure must be built
behind the plaster or sheet rock.
The manufacturer assumes
no responsibility for injury or
damage caused by improper
installations.
FIGURE 4
DUCTED
DIMENSIONS
x = 28"
x = 30"
min
min
8'
8'
1 7/8"
3 7/8"
max
max
8'
8'
8 7/8"
10 7/8"
!
Version 02/12 - Page 5
Publicité
