D-Link DES-1005F Guide D'installation Rapide page 3

Connecting The DES-1005F/DES-
1008F To Your Network
DC Power Jack: Power is supplied through an external AC power adapter. Since
the switch does not include a power switch, plugging its power adapter into a power
outlet will immediately power it on.
Auto-MDI-X Function ports: Use these jacks (port-1 ~ port-4) for DES-1005F,
(port1 ~ port-7) for DES-1008F to connect stations to the hub. An Auto-MDI-X
function will automatically detect if a crossover is required and make the swap of
TX pair and Rx pair internally. With this function, straight-through cable can be used
for any connection. MDI to MDI-X connection rule is not necessary anymore. In the
switches, all TX ports are equipped with this function. You can use just straight-
throughtype of cables for all your connections.
100BASE-FX Fiber Port: The Fiber port supports 100BASE-FX 62.5/125µm
multimode fiber. The TX port have to link to others end RX port, and the RX port
have to link to others end TX port.
Duplex Mode Switch: The switch is to select the operation mode either to run in
full or half duplex mode for 100BASE-FX. When turning the switch to FDX, the fiber
port will run at full duplex or turn to HDX, the fiber will run at half duplex.
All manuals and user guides at all-guides.com