D-Link DES-1005F Guide D'installation Rapide page 2

All manuals and user guides at all-guides.com
Setup The DES-1005F/8F 10/100M
Fast Ethernet Switch
The setup of the Switch can be performed using the following steps:
A. Install the DES-1005F/8F in a fairly cool and dry place. See Technical
Specification for the acceptable operation temperature and humidity
ranges.
B. Install the Switch in a site free from strong electromagnetic source,
vibration, dust, and direct sunlight.
C. Leave at least 10cm of space at the left and right hand side of the Switch
for ventilation.
D. Visually inspect the DC power jack and make sure that it is fully secured
to the power adapter.
Do not stack any device upon the Switch.
Mounting the Switch on a Wall
The DES-1005F/8F can also be mounted on a wall. Two mounting slots are
provided on the bottom of the switch for this purpose. Please make sure that
the front panel is exposed in order to view the LEDs. Please refer to the
illustration below:
A. Mounting on a cement wall
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.
B. Mounting on a wood wall
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.
(1) 3/4 inch minimum for
wood wall
(2) 3 inch minimum for
cement wall.