Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING:
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
(1) Allen wrench (For M5 hexagon socket bolt) ............................... 1 (attached to unit)
(2) One set of cutters .......................................................................... 1 (attached to unit)
(3) Deflection guard ............................................................................ 1
OPTIONAL ACCESSORIES.......
WARNING:
(1) Cutter (Fig. 25)(Code No. 319706)
* One set containing two pieces
(3) Center Roller (D 38) Set (Fig. 26)(Code No. 321445)
* This is used when the bending diameter of a rebar is changed to (bent diameter: ø38
mm).
1-1/2" (38 mm)
NOTE: Specifications are subject to change without any obligation on the part of the
HITACHI.
ACCESSORIES
Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.
Do not bend the rebar with #5 (5/8" in diameter) using the center roller
set (D38) and center roller set (D50).
Otherwise, there is a fear that the rebar may snap.
Fig. 25
Fig. 27
sold separately
(2) Center Roller (D 50) Set (Fig. 26)(Code No.
321446)
* This is used when the bending diameter
of a rebar is changed to (bent diameter:
ø50 mm).
2" (50 mm)
English
Fig. 26
23
Publicité
Table des Matières
