Power Fist 8465437 Mode D'emploi page 9

8465437
TROUBLESHOOTING
Contact Princess Auto Ltd. for a solution if the tool does not function properly or parts are missing. If unable to do
so, have a qualified technician service the tool.
Problem(s) Possible cause(s)
Motor will not start ON/OFF switch is in OFF position
Power cord is not plugged in
Electrical outlet does not supply
adequate power
Tripped GFCI plug
Tripped circuit breaker
Unit does not reach Diameter of garden hose is too small
high pressure
Water supply is restricted
Not enough inlet water supply
Water inlet filter is clogged
Nozzle is in low pressure position
Output pressure Not enough inlet water supply
varies high and low
Pump is sucking air
Water inlet filter is clogged
Discharge nozzle is obstructed
Calcium deposits in gun, hose, or wand Run distilled vinegar through detergent
No detergent Detergent container is empty
Detergent bottle or suction tube not
properly connected
Detergent is too thick
Filter on detergent suction
tube is clogged
Damaged or clogged detergent
suction tube
Nozzle is in high-pressure position
Discharge nozzle is obstructed
Garden hose Loose fittings
connection leaks
Visit www.princessauto.com for more information
1.6 GPM @ 2,000 PSI Electric Pressure Washer
Suggested solution(s)
Turn switch to ON position
Plug in power cord
Try a different outlet
Press RESET button on GFCI plug
Turn off pressure washer. Verify that only the
pressure washer is running on this circuit
Replace with 3/4 in. garden hose or larger
Check garden hose for kinks, leaks and blockage
Turn water on full force
Remove filter and rinse out in warm water
Push in head of spray wand to
high-pressure position
Turn water on full force. Check garden hose for
kinks, leaks or blockage.
Ensure hose and fittings are airtight. Turn off
unit and purge pump by squeezing trigger until a
steady flow of water emerges through the nozzle.
Remove filter and rinse out in warm water
Blow out or remove debris with thin,
sharp instrument
suction tube
Add more detergent
Check connections
Dilute detergent
Run warm water through filter to remove debris
Remove obstruction or replace detergent
suction tube
Pull out head of spray wand to
low-pressure position
Blow out or remove debris with thin,
sharp instrument
Tighten fittings
V 3.01
9