Publicité
Les langues disponibles
Les langues disponibles
8465437
CAUTION: This unit has been designed for use with pressure washer detergents only. The use of other
detergents or chemicals may damage the unit.
6. When detergent is no longer needed, insert the detergent suction tube into a container of fresh water.
7. Set the nozzle to the low-pressure setting.
8. Squeeze and hold the trigger for 20 to 30 seconds, allowing fresh water to rinse through the detergent
injection system.
TAKING A BREAK
1. Engage trigger lock (#4).
2. Turn ON/OFF switch (#3) to OFF/0 position.
SHUTTING DOWN
1. Turn the ON/OFF switch (#3) to OFF/0 position and unplug cord (#17) from outlet.
2. Turn off the water supply.
3. Squeeze trigger for 20-30 seconds to de-pressurize the system.
4. Release trigger and engage trigger lock (#4).
5. Disconnect the garden hose from the water inlet (#16) on the unit.
WASHING BEST PRACTICES
1. Before cleaning any surface, start with an inconspicuous area to test spray pattern and distance for
maximum cleaning results.
2. Pre-rinse cleaning surface with fresh water.
3. If using detergent or degreaser, apply to surface at low pressure. Allow detergent to remain on surface
1 to 3 minutes.
4. Do not allow detergent to dry on surface. If surface appears to be drying, simply wet down surface with
fresh water.
5. Always apply detergent from bottom to top.
6. Rinse at high pressure in a sweeping motion, keeping the spray nozzle approximately 3 to 9 inches from the
cleaning surface.
7. Always rinse from top to bottom and from left to right.
8. For best results on decks, cement patios, brick and stone, limit your work area to smaller sections of
approximately 25 square feet. When moving on to a new section of the cleaning surface, be sure to overlap
the previous section to eliminate stop marks and to ensure a more even cleaning result.
NOTICE: For softer woods, increase the distance from the cleaning area.
9. For best results on cars, boats & motorcycles, clean one side of vehicle at a time. Keep the spray nozzle
at least 8 inches from the cleaning surface. Increase distance when rinsing pin-striping or other sensitive
surfaces. Wipe surface dry with a chamois or soft dry cloth.
10. For best results on barbecue grills, outdoor power equipment & gardening tools, it may be necessary to
move the spray nozzle even closer to the surface for greater dirt-cutting action.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to control and will
have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or worn components.
3. Follow instructions for lubricating and changing accessories.
4. Keep the tool handles clean, dry and free from oil/grease at all times.
WARNING! Only qualified service personnel should repair the tool. An improperly repaired tool may present a
hazard to the user and/or others.
Visit www.princessauto.com for more information
1.6 GPM @ 2,000 PSI Electric Pressure Washer
V 3.01
7
Publicité
