AquaScape DIY Backyard Pond Kit Mode D'emploi page 14

STEP 16
PLUG IN AND TWEAK THE WATERFALLS
• As soon as the pond is filled and all of the black waterfall
foam is dry, you may plug the pump in and test the
waterfall.
WARNING
Any electrical should be plugged into a GFCI rated
receptacle.
• You can tweak the waterfall flow by placing smaller stones
and gravel on the waterfall cascades. This will change the
appearance and sound of the water. Have fun playing with
the flow of water coming over the falls until you achieve the
desired effect.
STEP 17
TRIM THE LINER
• With everything running, go around the perimeter of the
pond with a pair of scissors and trim off any excess liner,
always leaving several inches above the water level as a
precaution. The remaining liner edges can be covered with
gravel. sod or mulch.
WARNING Do not trim the liner until the waterfall is
running and the pond is filled to the desired level.
Prematurely trimming the liner may cause leaks!
STEP 18
MULCH AND LANDSCAPE
• The entire area surround-
ing the basin can now be
mulched and any surround-
ing plants added.
14
All manuals and user guides at all-guides.com
STEP 19
CLEAN UP
• You're at the final stages of the project! All that is needed
STEP 20
ENJOY!
• No further explanation needed for this step!
Scan the QR below or visit www.aquascapeinc.com for
more information on trouble shooting, maintenance and
complementing products for your new Aquascape Pond.
☎
US 1-866-877-6637 |
now is to clean up the mess you've made around the yard.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com