Publicité
Les langues disponibles
Les langues disponibles
Forward / Reverse Switch
Left Valve Knob
Push Knob in
for FORWARD
Before each use:
• Drain water from air compressor tank and
condensation from air lines. (Please refer to
air compressor's operation manual.)
• Lubricate the tool. (Please refer to the
"Maintenance" section in the manual.)
• Select the necessary impact sockets.
The sockets have to match with the size of the
drive on the air impact wrench.
• Connect air impact wrench to air source with
the hose of recommended size.
3/8"
Square
Drive
Trigger
Air Exhaust
All manuals and user guides at all-guides.com
Torque
Adjustment
Air Inlet
To use:
• Turn on the air compressor and allow its tank
to be filled.
• Set the air compressor regulator to 90 PSI.
This air ratchet wrench operates at a maximum
of 90 PSI. air pressure.
• Adjust torque regulator on the
(if it is available) to desire torque.
• Adjust tool either in forward or reverse
position, the job.
"F" for forward direction or "R" for reverse
direction.
• Depress the throttle control lever to start
operating the tool.
• Release throttle control lever in order to stop
the tool.
• When changing sockets, always disconnect air
supply to avoid injury.
• When job is completed, turn off the air
compressor and store the air tool after
lubrication.
High Torque
Turn the Valve Knob for more air flow and
more power.
Right Valve Knob
Push Knob in
for REVERSE
Low Torque
Publicité
