Publicité
Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (E).
NOTE: You may need to gently tap in the
å
MOLDING CONNECTORS.
www.sauder.com/services
These holes must line
up over the SHELF (E).
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(51 used in this step)
F
418546
1N
NAIL
Using your
hammer, getnly
tap in MOLDING
CONNECTORS.
Page 13
Publicité
