DNT WT8 Notice D'utilisation page 36

All manuals and user guides at all-guides.com
General operation
Monitor function
With the monitor function you can switch off the automatic squelch to
listen to the weakest signals, which are cut from the automatic squelch.
To activate the monitor function proceed as follows:
Channel scan
Busy channels can be automatically scanned.
To start the scan function proceed as follows:
When the radio detects channel activity, it stops scanning and stays
at that channel for 10 seconds. If the PTT button is pressed within the
10 seconds the radio will stay on that new channel, stores channel and
CTCSS code from the received signal, otherwise it will continuously scan
up to the next channel.
1. Press the Up-/Down button until
appears on the display.
2. Press the On/Off button to confi rm. The display
shows
signals is heard.
3. To switch off the monitor function press the On/Off
button again.
1. Press the Up-/Down button until
appears on the display.
2. Press the On/Off button to confi rm.
3. Use the Up-/Down button to move the arrow to
or to set the scan direction.
4. Press the On/Off button to start scanning.
5. To stop scanning press the On/Off button again or
PTT.
- 36 -
, the channel no. and noise of weak