Taurus Hipnos Power Mode D'emploi page 21

All manuals and user guides at all-guides.com
Interchangeable heads (Fig 4):
U blade (A)
- Suitable for trimming beard, mous-
tache and sideburns.
- Can be used with or without guide
comb 1, depending on the desired
cutting height.
T blade (B)
- Suitable for nape and extended
areas.
- Can be used with or without guide
comb 2, depending on the desired
cutting height.
Precision blade (C)
- Suitable for precision trimming, to
achieve a perfect finish or making
"drawings" on hair.
- Can be used with or without guide
comb 1, depending on the desired
cutting height.
Nose/ear trimming head (D)
- Suitable for trimming hair from the
nose and ears.
- IMPORTANT: do not insert it more
than 5 mm inside the nose or ears.
- Slowly move in and out while the tri-
mmer revolves to remove the unwan-
ted hair. For improved results, ensure
that the end of the trimming head
touches the skin. This will reduce the
tickling sensation that can be caused
by nasal hair.
Use:
- The appliance can be used directly
connected to the mains, or by using
his batteries.
- Unroll the cable completely before
plugging it in.
- Ensure that the electronic connector
is properly attached to the appliance.
- Connect the appliance to the mains.
- Turn the appliance on, by pressing
the on/off button.
Once you have finished using the
appliance:
- Turn the appliance off, pressing the
on/off button.
- Clean the appliance.
Cleaning
- Disconnect the appliance from the
mains and allow it to cool before
undertaking any cleaning task.
- Remove the head from the appliance.
- Use the cleaning brush (O) to remo-
ve the hair from inside the appliance
and the blades.
- Put the head under running water to
achieve a cleaner result if needed.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Never submerge the appliance in
water or any other liquid or place it
under running water.
- During the cleaning process, take
special care with the blades, as they
are very sharp.