Taurus Hipnos Power Mode D'emploi page 19

All manuals and user guides at all-guides.com
during a few seconds.
- Make sure that the appliance is
serviced only by specialist personnel,
and that only original spare parts
or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow
the instructions for use renders the
guarantee and the manufacturer's
liability null and void.
Charging the battery
Caution: A new battery is not fully
charged and must therefore be char-
ged before the appliance is used for
the first time.
- Charge the battery at an atmosphe-
ric temperature of between 4 and
40ºC.
- Plug the charger (L) into the mains.
- Approximately 8 to 10 hours are
needed for a complete charge of the
battery. Never attempt to over charge
the battery (although it is recommen-
ded that the first charge of the battery
be of 10 hours in duration).
- Connect the charger (L) to the char-
ging base (K) or to the appliance (E)
using the sockets in them. The socket
is located at the lower/back part of
the appliance and on the back of the
charging base.
- The pilot light will come on to
indicate that the charger is charging
the battery.
-- When the battery is charged dis-
connect the charger from the mains
supply.
NB: For a long battery life, it is
advisable to charge the battery, only,
when it has run out completely.
Instructions for use
Before use:
- Before using this product for the
first time, it is important to make a
full charge of batteries.
- Prepare the appliance according to
the function you wish to use:
Insertion of cutting head:
- Press down the blade attachment
switch and place the blade head until
it fits correctly. Release the blade
attachment switch (Fig.1).
- To extract the blade head, press
down the blade attachment and pull
out the head.
Insertion of comb guide:
- Guide comb 1 fits in Precision and
U blades only.
- Guide comb 2 fits in T blade only.
- Insert the blade to the end of the
guide comb 1.
- Slide down the guide comb 1 from
top to the bottom straightly until
it gets inserted correctly, hearing a
"click".
- To extract the comb guide, press the
guide comb sliding it from the end of
the blade.
- Take the guide comb 2 and fit the
end of the comb to the end of the
blade head.
- Press in the middle of the comb
until it gets inserted correctly, hearing
a "click"
- To remove the guide comb 2 pull
out the bottom clip, then one of the
side clips, and then pull the comb to
get it removed (Fig.3)