Dirty Pro Tools A805 Manuel D'instructions page 10

USER GUIDE
ASSEMBLY INSTRUCTIONS
ADJUSTING THE WORK TABLE FOR VERTICAL SANDING
1. Remove the Hex Screw, Lock Washer, Flat Washer and Backstop.
2. Unscrew and remove the Knob.
3. Pull the index pins out of the mounting holes in the Table Support.
4. Loosen the Hex Socket Screw and raise the Bed to the desired sanding position.
5. Insert the index Pins of the Table Support into the Auxiliary Holes in the Bed.
6. Retighten the Hex Socket Screw.
Please Note: Check to make sure the Worktable is not touching the Sanding Belt.
LEVELLING THE WORKTABLE
3. If the Worktable is NOT 90° to the Sandpaper Pad, loosen the Knob and tilt the
Worktable until the combination square is flush with the Pad.
4. Retighten the Knob to secure the Worktable in place. Then attach the Scale Level to the
"0°" mark on the Dust Collector.
10
All manuals and user guides at all-guides.com
1. Place a combination square on the
Worktable so that the square also
touches the Sanding Pad.
2. If the Worktable is 90° to the Sandpaper
Pad, the combination square is flush on
the Pad.