Dremel AT01-PGA Manuel D'instructions page 9

Fig. 4
12
11
10
9
2
2610046267.indd 9
All manuals and user guides at all-guides.com
Assembly
Fig. 5
12 11
90°
10
9
2
3. Place sanding disc on the mandrel to a point just below the
bow tie on the mandrel 10 and twist 90 degrees until the bow
tie interface 11 on the sanding disc 12 aligns with the sleeve
9. Release sleeve 9. Sanding disc 12 should lock in place
(Fig. 5).
Incorrect seating of sanding disc on
mandrel may lead to personal injury or
property damage. To check for proper seating, hold shaft lock
button 2 and twist the sanding disc 12. The sanding disc 12 will
not be able to rotate on mandrel.
To unload sanding disc:
1. Pull spring-loaded sleeve 9 DOWN toward tool with one hand
(Fig. 5).
2. Hold sleeve 9 down while twisting sanding disc 12 90 degrees
(Fig. 5).
3. Remove sanding disc 12 (Fig. 5).
9
3/2/17 1:00 PM