Dremel AT01-PGA Manuel D'instructions page 10

Fig. 6
2
7
10
2610046267.indd 10
All manuals and user guides at all-guides.com
Assembly
A
6
B
3
1
C
To attach nail guard attachment:
Note: Make sure that the mandrel and the sanding disc are
mounted properly before mounting the attachment.
A. Detach the clear cap 2 from the attachment by running the
small knobs 6 on the inside of the clear cap up along the
height adjustment guide 7 until they reach the guided open-
ing (Fig. 6).
B. Unlock the clasp 3.
C. Open the attachment 1 (Fig. 6).
D. Position the attachment 1 around the threaded nose of the
tool 8 and close the attachment together until the clasp 3 is
fully engaged (Fig. 7).
E. Turn the whole attachment 1 clockwise to screw it into place
on the threaded nose 8. Make sure that it is securely tightened
so that it will not shift positions during use (Fig. 7).
F. Re-attach the clear cap 2 (simply perform step A in reverse
order).
3/2/17 1:00 PM