Publicité
Les langues disponibles
Les langues disponibles
V 1.01
MAINTENANCE
Before making any adjustments or changing any accessory, turn off the tool and unplug it from its air source.
1. Check for damaged parts. Before using any tool, any part that appears to be damaged should be carefully
checked to determine that it will operate properly and perform its intended functions. Check for alignment and
binding of moving parts, for broken parts or mounting fixtures, or for any other condition that may affect proper
operation. Any part that is damaged should be repaired or replaced by a qualified technician.
2. When servicing, use only identical replacement parts. Only use accessories intended for use with this tool.
Replace damaged parts immediately.
3. Keep the tool clean. Wipe the tool with a clean cloth and periodically blow out all areas with compressed air.
If compressed air is not available, use a brush to remove dust from all areas. Do not use harsh chemicals or
solvents to clean the tool.
4. Regularly inspect all mountings and screws to ensure tightness. Should any screws become loose,
tighten immediately.
5. If repairs are required, bring your tool to an authorized service center.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling facility.
AIR TOOLS
AIR SOURCE INSTALLATION
1. Set the air pressure regulator on the air compressor to 90 PSI. Do not exceed the tool's recommended air
pressure. Excess pressure could result in damage to the tool, to your work piece or serious injury.
2. Prepare a standard 1/4" air connector for use with your tool. Wrap the threaded portion of the air connector
with thread tape. Attach it to the tool's air inlet. Tighten securely.
3. Attach a standard quick connector to the air source's hose. Attach the air hose to the tool.
Note : Unless you are using an in-line oiler, add a few drops of air tool oil in the tool's air inlet before use.
In the same manner, add a few drops after every hour of use.
4. Check the air line and its connections for air leaks. Do not use this tool until you have repaired all air leaks.
Note : Turn off the air compressor, disconnect the air pressure hose and discharge any residual pressure
inside the tool before changing accessories or making any adjustments to the tool. Failure to do so
could result in severe injury, tool or property damage.
10
All manuals and user guides at all-guides.com
Fluxchipper and Needle Scaler Kit
For technical questions call: 1-800-665-8685
8345381
Publicité
