Dremel PC10 Consignes De Sécurité/D'utilisation page 15

1600A018W0AA 02-18 PC10.qxp_Layout 1 2/7/18 7:28 AM Page 15
turned "OFF" before changing accessories,
changing backing pad, removing splash
guard, or servicing your cordless rotary
tool.
ATTACHING SPLASH GUARD
To attach splash guard: line up pins on the
guard with the slots on the tool housing (Fig. 2).
Twist in a clockwise direction until it is snug on
the tool. You must attach the splash guard be-
fore attaching the backing pad.
ATTACHING BACKING PAD
To attach backing pad: align with the threads of
the output shank and finger tighten the pad in
a clockwise direction (Fig. 2).
ATTACHING ACCESSORIES
Accessories are attached to backing pad by
hook-and-loop system.
To attach: align "loop" side of accessory to
"hook" side of backing pad on the tool (Fig. 2).
Align accessory as close to center as possible
on the backing pad so it spins concentrically for
optimal performance and ease of use. The ac-
cessories will overhang the backing pad, which
allows the user to get into corners and tight
spaces.
All manuals and user guides at all-guides.com
Assembly
To reduce the risk of injury,
always be sure the tool is
Pin
Backing
Pad
Loop
Side
Accessory
FIG. 2
Slot
Shank
Splash
Guard
Bristle
Brush
15