Pleasant Hearth OFG112SE Manuel D'instructions page 8

ASSEMBLY INSTRUCTIONS
1. Turn over the table top (E) and lay it flat on
floor. Attach the legs (G) to the table top (E) by
inserting three M6x10mm bolts (AA) through each
leg (G) and into the pre-installed nuts on the
underside of the table top (E). Secure all
hardware, but do not tighten at this time.
Hardware Used
AA
M6x10mm Bolt
2. Attach the three side panels (H) to the legs
(G) by inserting M6x10mm bolts (AA) through the
side panel (H) and into the pre-installed nuts on
the legs (G). Tighten all hardware, including parts
from step 1, with screwdriver. Do not install any
side panel to the side with control panel. Do not
install the door panel (I) at this time.
Hardware Used
AA M6x10mm Bolt
3. Insert four M6 x 10mm stepped bolts (BB)
through the pre-installed nuts on the two legs (G)
that are on the same side as the control panel.
Tighten with screwdriver.
Hardware Used
M6x10mm
BB
Stepped Bolt
All manuals and user guides at all-guides.com
x 12
x 12
x 4
8
1
G
AA
E
2
H
AA
3
G
G
BB