DWT BH09-26 Notice Originale page 14

Symbol
power tool designation
Rotary hammers are designed for impact drilling (in
masonry, concrete and stone), and chiselling - making
of cable ducts, removing ceramic tiles, etc.
[BH09-26, BH11-28, BH14-32]
The design enables impactless drilling (in wood, steel,
ceramics and synthetic materials).
Power tool
components
1 Сhuck DWT PLUS
2 Dust protection casing
3 Fixing bush
All manuals and user guides at all-guides.com
Meaning
"Impact drilling" mode.
"Chiseling" mode.
Prohibited.
Double insulation / protec-
tion class.
Attention. Warning of possi-
ble user health damage.
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards.
Attention. Important.
Useful information.
Wear protective gloves.
Do not dispose of the power
tool in a domestic waste
container.
DWT
4 Additional handle *
5 Clamping screw *
6 Depth stop *
7 Function switch (drilling / chiselling)
8 Ventilation slots
9 Cap
10 Percussion gear switch (drilling / percussion drilling)
11 On / off switch
12 Flange wrench *
13 Tube with lubricant *
14 Dust collector *
15 Сhuck DWT MAX
16 Function switch (percussion drilling / chiselling)
17 Speed selector thumbwheel
18 Light indicator
19 Gear rim chuck *
20 Adapter DWT PLUS *
21 Screw *
22 Drill chuck key *
23 Lock button
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
Additional handle (see fig. 1)
Always use the additional handle 4 when operating.
Additional handle 4 may be positioned as deemed
comfortable by the user.
• Loose additional handle 4 as shown in fig. 1.
• Place additional handle 4 in desired position.
• Tighten additional handle 4 as shown in fig. 1.
Depth stop (see fig. 2-5)
Use depth stop 6 to set a required drilling depth (see
fig. 2).
[BH09-26, BH11-28]
• Loose additional handle 4 as shown in fig. 2.
• Move depth stop 6 to set a required drilling depth
(see fig. 3).
• Tighten additional handle 4 as shown in fig. 2.
[BH-1200, BH12-40 V, BH14-32]
• Slacken clamping screw 5 (see fig. 4).
• Move depth stop 6 to set a required drilling depth
(see fig. 5).
• Tighten clamping screw 5.
English
14