Publicité
Les langues disponibles
Les langues disponibles
Fax +32 2 359 95 50
into the motor block until it clicks into place (1, 2 & 3). Then you can use the
appliance as a stick vacuum cleaner.
To remove the stick, pull the stick release button and slide both parts in the opposite
direction compared to the assembly (4 & 5).
•
Attach the desired suction tool (floor brush or crevice tool) to the nozzle of the dust
collector if necessary.
CAUTION: When using your appliance with the stick, you have to hold the appliance by the
handle and avoid pressing on the stick itself, as this could bend or break the stick or the
appliance and this will not be covered by the warranty.
USE
•
When the appliance has been assembled properly, unroll the power cord in order to
obtain the desired length of power cord. Insert the plug into the power socket and switch
on the appliance with the on-off switch.
•
The floor brush can be used for daily cleaning of large surfaces, hard floors or fitted
carpet.
•
The crevice tool can be used for mattresses, couches, curtains or wallpaper. You can also
use this crevice tool to avoid scratching the nozzle of the dust compartment.
•
When using the appliance as a stick vacuum cleaner you can attach the power cord to
the hook of the handle for convenient handling.
AFTER USE
•
Switch off the vacuum cleaner with the on-off switch.
•
Unplug the appliance from the power supply and roll up the power cord.
•
If necessary, disassemble the stick and the suction tool used.
EMPTYING THE DUST COLLECTOR
•
Hold the dust collector over a dustbin, press the unlocking button to open the lower
cover of the dust container and spill the rubbish.
•
Close the lid of the dust collector until it locks in place.
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes
except
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
11
Assembly page 11/32
under
special
instruction
TKG SKV 1001 - 141221
from
Team
Publicité
