Publicité
Les langues disponibles
Les langues disponibles
Installation of the welding wire
When fitting a new reel, please follow the following steps:
1.
Remove the shroud from the torch and unscrew the contact tip.
2.
Fit the wire reel onto the spindle. The spring mounting must be correctly
fitted.
3.
Locate the free end of the wire usually positioned in a hole on the reel rim.
Remove the end of the wire from the hole and use sharp wire cutters to
remove any distorted wire. Do not allow the wire to become slack on the
reel.
All manuals and user guides at all-guides.com
4.
5.
6.
7.
8.
Hinge back the pressure arm and feed the end of the wire into the hole in
the end of the liner. Ensure that the wire is fitted so that it is fed into the
wire feed mechanism in a straight line.
Fasten the pressure arm down ensuring that the MIG wire is in the groove
in the feed roller. Ensure that the correct groove is used depending on the
diameter of the wire i.e. one groove is for 0.6mm and the other for 0.8mm.
To reverse the roller, unscrew the two screws securing the roller,
supporting the bracket and remove the bracket. The roller can then be
removed from it's shaft and reversed.
Hold the torch straight. Switch the machine on and operate the torch
trigger, the wire feed roller will turn feeding the wire through the torch.
The wire will emerge from the far end of the torch, then feed the tip onto
the wire (make sure the tip is the correct size for the diameter of wire
being used), tighten it and replace the shroud.
GB
FR
95 | 96
EN
Publicité
