UFESA GS1600 Manuel D'utilisation page 16

AF-Manual-PLANCHA VERTICAL GS1600.pdf
MAINTENANCE AND CLEANING
MAINTENANCE AND CLEANING
After use it, please remove the water tank, empty the water tank completely, and then return the water
After use it, please remove the water tank, empty the water tank completely, and then return the water
tank to its place.
tank to its place.
Before cleaning the garment steamer ensure it is unplugged from the power supply and has completely
Before cleaning the garment steamer ensure it is unplugged from the power supply and has completely
cooled down.
cooled down.
Do not use abrasive cleaners.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.
these will damage the surface.
Before storing in a cool, dry place, check that the garment steamer and any accessories are cool, clean
Before storing in a cool, dry place, check that the garment steamer and any accessories are cool, clean
and dry.
and dry.
Never wrap the cord tightly around the garment steamer; wrap it loosely to avoid causing damage.
TROUBLESHOOTING
TROUBLESHOOTING
Problem
The garment steamer is not heating
C
up.
The power indicator light is not
M
illuminating
Y
CM
MY
CY
No steam is being emitted from
CMY
the garment steamer.
K
The garment steamer is making
an abnormal sound
16
16 11/3/21 11:26
All manuals and user guides at all-guidesbox.com
Possible Cause
The garment steamer is not
plugged into the mains power
supply.
There is insu cient water
remaining in the water tank.
The appliance has not reached the
required temperature.
The steam trigger is not held down.
The water tank is not securely
locked.
The water tank is empty.
Solution
Plug in and switch on the garment
steamer at the mains power supply.
Fill the water to at least the min fill
mark and not beyond the max.
Plug the garment steamer at the
mains power supply and allow it to
preheat su ciently. This should take
approx. 30 seconds.
Hold down the stream trigger.
Make sure that the water tank is
securely pushed into place.
Refill the water tank to the max fill
level.