Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
"Add Water"
indicator lights up
"Ice-Full" indicator
lights up
"Power" indicator
and ICE icon
flashing
Making Ice too
slowly
Water leakage
POSSIBLE CAUSE
Lack of Water.
There is too much ice.
(No ice cube inside).
Ambient temperature or water
temperature in inner tank is too high.
Refrigerant liquid leakage.
Cover motor is broken.
Pipe in the cooling system is blocked.
Hot Air outlet has been blocked by
something.
Water temperature in inner tank is
too high.
Refrigeration system malfunctions.
Drain plug not in place.
Pipe Joint in the appliance may
Loose.
The seal has reached service life
TROUBLESHOOTING
SOLUTION
Stop the ice maker, fill water, and
press "ICE"/"CLEAN" button again
to restart the unit.
Suggest you to obtain the ice-cube.
Remove the probable obstacle
inside or clean the inside wall of
the ice storage.
Press and hold the ice making
button for 5 seconds to forcibly
cancel full ice and restart ice
making for 80 minutes.
Please run the ice maker below
90 Fahrenheit degree ambient
and pour colder water into tank.
Press the ICE button twice, restart
ice making program, if this problem
show up again, verify by a qualified
technician.
Hot Air outlet must be guaranteed
to have more than 15 CM of
ventilation distance.
Water temperature requirement
between 44.6℉-89.6℉.
Verify by a qualified technician.
Put the drain plug in place.
Verify by a qualified technician.
Verify by a qualified technician.
9
Publicité
