Publicité
Les langues disponibles
Les langues disponibles
HEADLINE
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the motor bike is 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 7 for charging information).
Brake Lever
Front Fork
Required Tools
4 mm, 5 mm and 6 mm
Allen Wrenches (included)
Parent Controlled
HIGH/LOW
Speed Switch
Charging Port
Chain Guard
Phillips Screwdriver
(included)
2.
Charger
Note: Charger design may
vary from one shown
Power Switch
1.
8 mm/ 10 mm Wrench
(included)
3
3
WARNING:DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR ELECTRIC MOTOR
BIKE. The electric motor bike
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
your warranty.
Product ID Locations:
(See locations to the left)
1. Underneath Frame
2. Charger
3. Battery Cover
4. UPC Side of Box (not shown)
Throttle
3.
Plastic Bag Contents:
• Charger
• Tools
• Handlebar Clamps
• Owner's Manual
Publicité
