DeWalt D25102 Mode D'emploi page 29

• Always switch off the tool when work is finished
and before unplugging.
Rotary drilling (fig. A)
• Set the mode selector switch (4) to the "rotary
drilling" position.
• Depending on your tool, follow either of the
following instructions:
- Fit the chuck adapter/chuck assembly
(D25102(K)/D25102C/D25103K/D25203K).
- Replace the tool holder with the chuck
(D25104K).
• Proceed as described for hammer drilling.
Never use standard chucks in the
hammer drilling mode.
Screwdriving (fig. A)
• Set the mode selector switch (4) to the "rotary
drilling" position.
• Select the direction of rotation.
• Depending on your tool, follow either of the
following instructions:
- Insert the special SDS-plus
adaptor for use with hexagonal screwdriver bits
(D25102(K)/D25102C/D25103K/D25203K).
- Replace the tool holder with the chuck
(D25104K).
• Insert the appropriate screwdriver bit.
When driving slotted head screws always use
bits with a finder sleeve.
• Gently press the variable speed switch (1) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
• When the screw is flush with the workpiece,
release the variable speed switch to prevent the
screw head from penetrating into the workpiece.
D25103K/D25104K/D25203K - Chipping and
chiselling (fig. A)
• Set the mode selector switch (4) to the
"hammering only" position.
• Insert the appropriate chisel and rotate it by hand
to lock it into one of 51 positions.
• Adjust the side handle (9) as required.
• Switch on the tool and start working.
• Always switch off the tool when work is finished
and before unplugging.
® screwdriving
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
Various types of SDS-plus
available as an option.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• This machine is not user-serviceable. Take the
tool to an authorised D
approximately 40 hours of use. If problems occur
before this time contact an authorised D
repair agent.
• The tool will automatically switch off when the
carbon brushes are worn.
Lubrication
Your power tool requires no additional lubrication.
Accessories and attachments used must be
regularly lubricated around the SDS-plus
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
®
drill bits and chisels are
WALT repair agent after
E
WALT
E
®
fitment.
WALT repair
E
29