Publicité
Les langues disponibles
Les langues disponibles
Turn on/off the unit
1. Plug the small end of the power plug into your turntable, the big one to the wall outlet.
Note: The supplied AC adaptor is suitable for use on AC main supplies of 100-240V
AC and should only be connected to a mains supply within these parameters.
Rotate the POWER switch clockwise until a "click" is heard; then the POWER lamp
2.
will turn red, which means the unit is powered on.
3.
To turn off the unit, rotate the POWER /VOL switch counter-clockwise until a "click"
is heard to turn off the unit. the POWER lamp turns off, which means the unit is
powered off.
Charge the built-in battery
The built-in battery provides you with music when the player is inconvenient to be
connected to power supply.
1. When the player is connected to power supply, the CHARGE lamp will turn red if the
rechargeable battery inside has not been charged fully, and will turn off automatically if
the battery fully charged.
2. If some beeps is heard when the player is powered by the built-in battery, it indicates
that the power in the battery will be used up. It is advised to connect the player to
power supply immediately, or the player will be forced to stop automatically in less
than 20 minutes due to lack of power.
Note: Do not use up the power in the built-in battery, as it will do harm to the battery's
capacity.
GENERAL OPERATIONS
DC
IN
L
R
5V
1.0A
To DC in 5V jack
6
Publicité
