Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
3
Fender Protector
Installation
4
Align fender protector with front edge of fender. With the fender
protector in final position, remove the remainder of the tape liner by
pulling on loose ends. Press firmly on flanges to ensure adhesion.
6
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
NOTE: Actual application may vary slightly from illustrations.
Using a phillips screwdriver, install the fastener
Clean the fender protector mounting
location with an alcohol pad.
A U T O M O T I V E
P R O D U C T S L I M I T E D
2435 WISCONSIN STREET
DOWNERS GROVE, IL 60515
PHONE (630) 769-1500 FAX (630) 769-0300
(800) 441-MATS (6287)
INTERNET ADDRESS: http://www.macneilauto.com
DO NOT OVERTIGHTEN
Expose 2" (5 cm) of tape liner from each end of the flanges
5
Apply bump on as indicated.
7
Repeat Steps 4-7 for passenger side fender protector.
Page 2 of 2
front grill
fastener
on the fender protector.
hood shield
Publicité
