Camp Chef SmokePro PG24DLX Manuel D'instructions page 6

twice a year to determine when grease and or creosote buildup
has occurred. When grease or creosote has accumulated, it should
be removed to reduce risk of fire. Use a wire brush to clean the
screen area of the chimney outlet on the inside of the grill with
every 50 hours of use.
TROUBLESHOOTING
GRILL DOES NOT TURN ON.
Grill fails to turn on after switching the power button to the
on position.
1. Make sure the grill is plugged into a powered outlet. Check
the circuit breaker and/or GFCI switch. Test the outlet using
another appliance.
2. Unplug the grill and check the fuse located in the front panel. If
the fuse is blown replace only with 5.0 Amp 250V 5x20mm Slow
Blow Fuse. Typical fuse marking will be T5AL250V. Make sure to
confirm they are a slow blow fuse. Actual fuse dimensions are
5.2x20mm.
If problem cannot be resolved please call customer service.
GRILL DOES NOT HEAT UP OR DIGITAL READOUT DISPLAYS FLAME
1. Turn Power Off
2. Check hopper for pellets
3. Check firebox to see if there are pellets in the firebox. The
easiest way to do this is to pull the burner clean-out lever.
Then remove the cup from the bottom of the grill and check for
pellets. Use a vacuum to clean-out any pellets that may be in
the bottom of the grill.
A. If there are a lot of pellets in the cup. Reinstall the cup and
close the burner clean-out, remove the grill grates, grease tray,
and heat deflector and vacuum out any pellets in the bottom
of the grill. Try restarting the grill. If restarting the grill does
not work and pellets are getting to the burner cup the heating
rodmay need to be replaced.
B. If there are few or no pellets in the cup then turn the dial to the
feed position and see if pellets fall out the bottom of the burner.
If there are no pellets check to see if the auger is turning. If
the auger motor is turning but the auger is not there may be
a sheared auger pin. You can determine if the auger motor is
turning by watching the small white fan at the end of the auger
motor under the hopper. If the white fan is turning the auger
motor is on. If the white fan is turning and the auger is not you
will need to replace the auger pin.
If problem cannot be resolved please call customer service.
DIGITAL READOUT DISPLAYS SENSR
1. Turn the power off and unplug the grill.
2. Check to make sure the sensor inside of the grill is connected
properly to the electronic board under the hopper.
3. Call customer service for a replacement sensor.
DIGITAL READOUT DISPLAYS PRERR
1. Press the Probe Temp button - Pressing the Probe Temp button
will toggle the digital readout between the actual temperature
All manuals and user guides at all-guides.com
inside of the grill and the temperature measured using the
meat thermometer.
2. Make sure the meat thermometer is connected properly to
the front of the grill. If the Probe Temp button is pressed to
display the Probe Temp without the meat thermometer properly
connected to the front of the grill it will display PRERR.
3. Call customer service for a replacement meat thermometer.
DIGITAL READOUT DISPLAYS "-----"
1. Rotate the dial from Shutdown to feed or any other cook setting.
LIMITED WARRANTY
To activate warranty, register on-line at: www.CampChef.com
The manufacturer warrants stove components (except
paint and finish) to be free from defect in materials and
workmanship for 1 year from the date of purchase. All
accessories (included with stove or purchased separately)
are warranted from defect in materials and workmanship
for 90 days from the original purchasing date. Within these
periods, the manufacturer will replace or repair defective
parts deemed unusable from its original intent by making
available the parts thereof
FOB Hyde Park, UT 84318
Product paint and finish is not warranted. The exterior finish
of the product will wear down over time.
Clean the unit after each use to maintain the finish and
prolong the life of your product. Wipe away all grease and
ashes. Keep metal products free of moisture, salts, acids
and harsh fluctuations in temperatures.
Warranty does not cover normal wear of parts or damage
caused by misuse, abuse, overheating and alteration.
Repairs or alterations made by anyone other than Camp
Chef are not covered in this Warranty. Manufacturer will
not be held liable for any losses due to neglectful operation.
Furthermore, this Warranty does not cover damaged caused
by natural disasters such as earthquakes, hurricanes,
tornadoes, floods, lightning, fires, etc.
Upon the expiration of this warranty all such liability will
terminate. No other warranties are expressed or implied.
Keep all original sales receipts. Proof of purchase is
required to obtain Warranty services. Prior written approval
and a Return Authorization Number must be obtained and
accepted for repair or replacement only. Returns must be
shipped prepaid. Collect shipment or shipments without a
Return Authorization Number will not be accepted.
To obtain Warranty services call 1.800.650.2433.
*Warranty applies to the contiguous US states only.
White
Black
Power Cord
Auger Motor Blower Fan
RTD Sensor
Controller
MOLEX Connector
Hot Rod
Burner