Camp Chef SmokePro PG24DLX Manuel D'instructions page 4

M8 X 45 BOLT
M8 FLAT WASHER
M8 LOCK WASHER
M8 NUT
Fig. 2
M6 X 76 BOLT
M6 NUT
M6 X 15 SCREW
CHIMNEY GASKET
INSTALL HANDLE
1. Install the handle as shown in figure 3.
2. Tighten all hardware.
Fig. 3
HANDLE SPACER
M6 X 15 SCREW
INSTALL SHELF
1. Install shelf as shown in Fig 4.
2. Tighten all hardware
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 4.
Fig. 4
ASH CUP
M6 X 15 SCREW
GREASE BUCKET
All manuals and user guides at all-guides.com
ASH CUP
1. Install Ash Cup as shown in Fig 5. Never use grill without Ash
Cup in place.
M6 LOCK WASHER
M6 FLAT WASHER
Fig. 5
M6 NUT
ASH CUP
HEAT DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip tray as shown in
Fig 6 and Fig 7.
Fig. 6
WARMING RACK
M6 X 15 SCREW
GREASE BUCKET
Fig. 7
WARMING RACK AND COOKING GRATE
1. Install the Warming Rack and Cooking Grate as shown in Fig 8.
Fig. 8
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when grill is on. Make
sure pullout lock is pushed down and locks the knob to prevent
inadvertent opening of the clean-out port. See Fig 9.
2. Lift pullout lock and pull clean-out port knob to empty ash into
ash cup. See Fig 10
3. See instructions for burner clean-out.
Fig. 9
DRIP TRAY
COOKING GRATE
HEAT DEFLECTOR
Fig. 10
DRIP TRAY
HEAT DEFLECTOR
CLEANOUT PORT KNOB
PROBE
1. Plug the Meat Probe into the Probe receptacle on the control
panel. Run the probe and wire through the probe access hole on
the side of the grill. See Fig 11.
2. See instructions for Meat Probe.
WARMING RACK
Fig. 11
COOKING GRATE
WARMING RACK
COOKING GRATE
BURNER CLEAN-OUT
Before each use the burner should be cleaned out by lifting the
pullout lock and pulling the clean-out port knob on the right side
of the grill to open the burner clean-out. This will allow the ash
from previous use to fall into the cup under the grill. The cup
should be removed and emptied and then reinstalled before
each use.
Never Operate the Pellet grill without the
ash cup in place.
Make sure the burner clean-out port is
closed and locked before starting the grill.
CLEANOUT PORT KNOB
Never open the burner clean-out port when
the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right side
of the grill. Make sure to lift the pullout lock and push the
clean-out port knob all the way in and lock in place with the
CLEANOUT PORT KNOB
pullout lock. Every 50 hours of use, remove the grill grates, grease
tray, and heat deflector and clean the inside of the grill. If you
notice a lot of ash blowing around in the grill it is time to vacuum
it out.
WARMING RACK
COOKING GRA
PROBE HOLE
PROBE
DANGER
CLEANOUT PORT KNOB
CLEANOUT POR