Publicité
Step 11
IMPORTANT: Units that are stacked on top of another
å
unit must be attached to each other as indicated in this
step. These units must be positioned against a wall and
the upper unit must be attached to a wall.
You may need someone's help in this step.
å
Remove the SKIRTS from the upper unit.
å
Fasten the upper unit to the lower unit. Use two SILVER
å
1-1/8" FLAT HEAD SCREWS (X) through the holes in the
underside of the TOP (C) and into the BOTTOM (D).
NOTE: The holes in the TOP are not through holes. Use
å
a little extra force while turning these SCREWS.
www.sauder.com/services
X
SILVER 1-1/8" FLAT HEAD SCREW
(2 used in this step)
STACKING OPTION:
(If not stacking units, go to step 12)
C
411591
D
Page 15
Publicité
