Publicité
Les langues disponibles
Les langues disponibles
Warning:
Do not leave your board under direct sunlight as this may cause
over-inflation.
Please keep the board under shade when not in use with a working pressure
NO MORE THAN 10psi, or leave your board in a cool dry place.
Remember to check the air pressure before and after use, and deflate your
board when necessary.
10psi
15psi
• Electric Pumps can be used to inflate board up to 80-90%. However, the
remaining pressure required should be achieved by using the hand
pump to avoid over-inflation.
• Do not use air compressors as this voids warranty of board.
• Before long trips, ensure the board has been inflated and has
maintained pressure for a minimum of 24 hours.
Slide-in Center Fin System
For Double Chamber Board ( HYPER )
For best performance, the double
chamber should always be inflated to
ensure the highest stiffness and safety.
• Inflate the inner chamber up to 10 PSI.
• Inflate the outer chamber up to 15 PSI.
PRECAUTION & TIPS
FIN INSTALLATION
SLIDE - Slide in
the large Center
Fin to the fin base.
10
INSERT - Insert
the push-in pin.
Publicité
